Check Input Data Consistency

(“Check” configuration of the solver)

Start the following steps in the Solver screen.

Set the solver configuration to “Check,” leave other parameters as they are.
Click Load.
The status of operations being performed by the solver can be seen in the frame in the lower left hand corner of the screen. When the solver is started, the Solver Status will automatically be displayed. The status is updated every 5 seconds.
When the solver status is “Awaiting commands…,” click Refresh in the Solver screen.
Scroll down on the Solver screen to the last section. If there have been any problems loading class data, a list of warnings will be displayed. For detailed warning descriptions see the Solver Warnings page.
Make any necessary changes to the input data to address problems described in the warning messages -- such as a class with no time pattern selected. Clicking on the underlined class will take you to the Class Detail screen from where you can fix these problems. You can return to the Solver screen by clicking on Solver in the left hand side menu.
When all problems have been corrected, you should return to the top of the Solver screen and click on the Unload button. This unloads the previous input data (that you have just changed using the Class Detail and other screens).
Repeat steps 1 through 7 until all unacceptable warnings are resolved. Note - these warnings are described in the Solver Warnings page. If a warning message says class not loaded this class will not be in your timetable.